Hombre,
Funny you should bring this up as I just read about this the other day. I won't spoil your fun, but for a quantitative answer, read 5.16 Rifle Recoil Studies here
http://www.thewellguidedbullet.com/mechanical_studies.htm
HTH
LR
Tar.
Find a neighborhood roofing project and grab a small chunk of roofing tar. Dissolve it in chloroform or other solvent (e.g. acetone) and apply. Leaves a very sticky film of zero thickness after carrier evaporates. Poor man's substitute for hydraulic brakes for bikes. Applied to bicycle...
Define "easily fabricated".
FWIW, 30 carbine blanks are commercially made from .223 cases so it's possible to reform more readily available brass into 30 carbine.
Just may not be "easy" or "economical" (for you or your purpose).
The structural cert (AWS D1.1) I had for mild steel of limited thickness used short circuit transfer (GMAW-S). GMAW-S is more than capable of adequately fusing such base metals (Xray qualified). Globular transfer in out of position welding is a nightmare, and spray is such a high heat process...
How short a case can 38spl safely use? What does one do with "short" brass?
I've never seen a minimum case length spec anywhere and case length will determine your OAL for a given bullet
Here's my all-time eureka moment
Reaming round the hole through my revolver's cylinder for the ejector rod to remove the sloppy manufacturing defect I found before, of course, I noticed the rod had a flat side, for a reason!
:cuss:
If it ain't broke, don't fix it, and when you do fix it...
Lee hand press hands down, so small and versatile, but I don't load 50BMG. The 550B I'm unpackaging today I'm hoping will be a bit faster though
:evil:
Seems tight too, but with an odd number of lands/grooves, the bores on S&W barrels are a little tricky to measure. You can't just whip out your dial calipers and measure the slug's diameter, directly anyway, after forcing it through the barrel.
Are you using precision shim stock?
As a lifer, I occassionally slip them $10 when I think they are doing a particularly good job, most recently in my mind followed a speech by Wayne L this Spring. When they are just ranting, I ignore them.
How about Uzi (Hebrew name meaning My Power)?
Seriously, I would never curse a child with an "unusual" or unique name in this digital age where privacy is virtually non-existent.
A $2 pair of tiny locking pliers (at either Harbor Freight or Lowes) is a great addition to the Lee trimmer But there's a better way.
Rather than trying to get ALL of my cases THE SAME LENGTH, like I used to do, I just accept the fact my case collection contains all different lengths. So, e.g...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.