Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
You are using the old High Contrast theme. We have installed a new dark theme for you, called UI.X. This will work better with the new upgrade of our software. You can select it at the bottom of any page.
I appreciate everyone's help.
I will keep this short for now and will follow up after more rounds through.
The gas block set screws came lose and the block did move and disconnect from the gas tube. I aligned and slid everything back into place and tightened the set screws. The gas block is not...
@MarshallDodge Interesting thing happened. As I was further checking how the gas block was attached, I discovered the two hex screws were lose and the gas block was able to slide back and forth about 3/16th of an inch. I think this would explain why the bolt remained closed after firing a round...
I removed the glacier guards, everything seems to be tight and straight. I can't really see the point of connection through the ejection port or from the bottom. It appears to fit but I can't really tell for sure.
I did take a can of compressed air and stuck the air tube into the gas tube where...
Winchester 223 55 grain
Frontier 556 55 grain
Tula 223 55 grain (Steel case)
Hornady VMax hand loads
All have worked flawlessly previously. Frontier, Tula and VMax were tried on Sunday and only the Frontier and Tula this morning.
Would a problem with the gas block/front sight alignment cause a...
Hey everyone.
Help please.
Factory stock DPMS Oracle 5.56 will not cycle/eject
I have approximately 2,000 rounds through with ZERO issues. cleaned frequently, every 300-500 rounds.
At the range yesterday, I set up 10 water bottles and the first 6 were dead on. #7 jammed-double feed. Cleared...
Lots of good advise here. as always.
If it was me, I would do as @mrawesome22-250 suggested. Either buy the Lee single carbide die or I would go with the complete die set including the taper crimp die and return the Redding.
I do believe that if the sizing die is not working correctly, the...
I have an idea.
I can let you borrow my Lee carbide sizing die. That should determine if it is an issue with the Redding sizing die or if it is something else.
Text me to arrange a time.
The head stamps are confirmed 9MM Luger. He has lubed the cased with a little and a lot of lube.
The die is clearly marked 9MM is it possible the die is incorrect? Is there another case similar that is necked down? The only case I can think of is a .357 Sig. I am guessing it is possible to fit...
I am asking a question for a friend that is brand new to reloading and having trouble setting up his resizing die. It is a Redding three die set #80172 and the sizing die is number 91172
He has followed the set up instructions and this is the result. I have searched here and the internet and...
I've done several of these on the list. Forgot to seat the primer before charging. Had 380 cases mixed in with 9's, weighing individual charges for a ladder work up and dumped the powder from the case on to the scale instead of back in to the hopper and various other stoopid things.
I just...
Inexpensive addition to the trimmer. Works great for me. The trim length is adjustable-
https://www.amazon.com/LEE-PRECISION-90275-Trimmer-Cutter/dp/B00162PVJQ
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.