Search results for query: *

I recently bought this to use for rifle priming. I had been using an old Lyman 310 tool but had to place primers in by hand one at the time. I like everything about this except changing the shell holder. Using my thumb to move that slide down to accept that shell holder is a pain. Very stout...

This is a real simple minded question. I have some standalone bullet tubes that fit in my Hornady bullet die. Both homemade and Hornady tubes. The homemade tubes are 36" long and made from brass tubes. At present I have them laying around. I would like to mount some kind of hanger to the side of...

I have seen this brand on reloading equipment at MidwayUSA. Where did they come from and is this MidwayUSA's proprietary brand? Apologizes in advance if this has already been answered, however I did a search and came up with nothing.

Yesterday I resized around 250 military and commercial 30-06 brass. I have been using Forster dies for rifle calibers for some time now. Previously I had disassembled the dies to clean. During this process I did not screw the expander ball back down to it lowest position. This would position it...

Well, I got busy reloading some 357 mag the other day and failed to use magnum primers with Alliant 2400. My pet load is 14.6 grains of 2400, 158 grn Remington JHP, and CCI 550 primer. I had just gotten finished loading some 40 cal using the SP (CCI 500) and honestly did not change primers. I...

I just read an article on the Midsouth Shooters Blog rationalizing why we should not cam over on any press. http://www.mssblog.com/2016/04/14/cam-over-dont-do-it-just-dont/ I have had Cam Over ingrained into my DNA but this article makes a lot of sense, especially when I am concerned about...

I have always used a primer pocket uniformer on my rifle brass. However I have gotten into shooting 40 S&W and was going to check the primer pockets like I normally do. I believe, however, that the depth of pistol and rifle primer pockets are different depths. If so, what brand do most of you...