Thanks man. I am new to this and just don't wanna blow myself or wife up.
I was beginning to think I had made a mistake with the type of powder I am using. Not much info out there on HS-6!
Shooting factory ammo in the kel-tec isn't even a consideration right now. I got into reloading to save money and mostly have fun. If I relegate one of my sidearms as un-reloadable-for :) then that would just plan stink.
Right now this load works well in the pf-9. I just want advice on...
okay..Thanks. Now you say my charge is light. I made it light because i was seating deeper than recommended on the Hodgdon website. These loads function in all 3 guns, working the slide and dumping the cases within a couple of feet of me. They also produce an actual pleasant experience with...
Loading for a kel tec pf-9, ruger sr9c, and a taurus slimline pt-709. would like to be able to use the same load with all.
The problem is the kel-tec. It is very finicky. The shells have to be short. I have finally found a load that works and I just want to post it here and see what ya'll...
My wife and I just bought our 4 year old a very light powered airsoft colt 1911 for Christmas. he is only allowed to handle it at the range and he must observe the 4 rules all the time or it is taken away.
Thanks this is cool info. I really like this site. Very helpful and patient with the newbs!
So would it be correct to say that the 4th die corrects, fixes and maybe even MASKS mistakes and problems??? Can this be dangerous?
Getting into reloading, as in doing tons of research before i buy anything. I have read the book "ABC's of reloading, 9th edition.
My confusion comes in when discussing taper crimps. Oh, btw I am just going to load handgun rounds. Mostly 9mm, maybe eventually
.380 and .45.
I am...
Pardon my ignorance but what type of weapon shoots this 9mm largo?
oh and just as a side note the case has a Berdan primer. I assume this confirms the above post.
Give me a lil bit and i will get a pic and post up with it laying beside some 9mm, 40 s&w and a 380 acp. I will also measure the case length and diameter.
Okay I couldn't find a metric ruler and my battery in my calipers are dead so standard measure will have to do... but i did convert using...
Picked up a ton of brass at the range today and found a few I cannot identifiy.
The head stamp says....SB-T 77 7-6
I found out..... SB stands for Santa Barbara and the T is Toledo, Spain.
I assume the 77 means 1977.
What is the 7-6??? caliber???
7.6 x??????
These are...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.