Search results for query: *

I grew up in NY with one shotgun that got cleaned and wiped down with CLP on the rare occasion it was shot. I moved to AZ and wound up adding several rifles and pistols to my collection. Same drill. Now I'm gonna be moving to where its more humid, very humid actually. Will this still protect...

Just curious if anybody knows why we pay hazmat fees for primers and powder but not on loaded ammo?? :uhoh:

I just pulled 700 or so cast bullets to salvage the brass. There is a blue ring of lube around the inside of the cases. I tried tumbling them first worked on some not others. I have the tumbler set out in the sun now hopefully heat will help (105* today). Anybody else ever run into this? Is...

I personally prefer to carry a sub compact in a concealed holster under a tee for EDC. If I'm carrying a compact or full size then I throw a button up shirt over it. I'm of the thought that if someone approaches me with hostile intent I dont want them knowing I'm armed until it's too late...

I'm thinking about moving to Georgia and I'm not sure if all my weapons/magazines/ ammo is going to be legal there. Obviously I wont advertise what I have but just in case.... I tried reading the laws and it drove me nuts. Can anyone break it down in Layman's terms? I'm mostly concerned...

This headache started when I got some HSM HC 100grn RNFP .356 dia. I wanted to load in my 380. Most of the data I find for RNL shows a Coal of .975 These need to sit at .965 to function in my pistol. I was wondering if anybody here has loaded these and what worked best. On hand I have all kinds...

I'm looking for something I can plug data into and get approximate pressure and velocity info. For one if I find a powder that produces higher velocities at lower pressures (this is good right?) and finding safe starting points. If I'm correct you can plug in the case capacity, powder, bullet...

CAUTION: The following post includes loading data beyond currently published maximums for this cartridge. USE AT YOUR OWN RISK. Neither the writer, The High Road, nor the staff of THR assume any liability for any damage or injury resulting from use of this information. The High Road has given...

An acquaintance says he had good results loading Rainier 124gr hp under about 7 gr of blue dot. I had enough info to start but no OAL. To start I measured a federal HST 124 gr. It came in at 1.100 and thats what I went with. The HST is .595 in length and and the Rainier is .551-.555 so I...

So I recently started loading 9mm and it was going well. I decided to get some Barnes Tac-XP 115 gr. Prior to this I was taking once fired, tumbling, Sizing priming, flaring, charging and seating. Done! Well I really wanted these Barnes to be something special and their load data specified a...

I have a chance to pick up some factory second jacketed HP. Seconds because these are .354" Would they be safe in 9mm luger loads for a Sig 229 or SP2022? Probably another dumb question but I'm new and figure I'll get a better answer than asking the guy whos trying to sell them to me :confused:

I recently purchased an AR lower from an online vendor. I happily assembled my rifle and went to town. Well a couple days later I was telling a friend about it and I took him to the web page to see the lower and the picture they displayed was my lower. Exact serial number plain as day. Typically...

I was trying to work up a load I couldn't find any data on using parts I already had on hand. To be safe I started with low charges. I've recently read on here that light charges may cause a rifle to detonate same as heavy charges. I'm a little concerned being extremely new to this so here's...

Though I would put this up to save someone the trouble I went through today. I was swaging some LC brass for the fist time today. I ran it all through my RCBS swager then began hand priming it. The hand primer was the non-universal RCBS one. A lot of the primers were seating really...