Search results for query: *

Greetings: I am not too new to reloading .308 Winchester. But recently ran into a little problem. I have a Hornady Progressive reloader and use Lee dies for my .308. I have followed the instructions, I have deprimed, re-sized and chamfered the inside and outside of the brass. But yet on a...

Hi Everyone; We'll I went to shoot my first .308 reloads and only 50% worked. One half were ok from a known source that the brass was only fired once. Second half were supposedly fired once also. But... Here's the problem. The rounds from another source would get stuck in the chamber...

Greetings: This is a two part thread / Question... Getting more into Trap and looking to get an over and under shot gun. I can see there is a lot of them, but I do have a budget of under $1,400.00 So for this money, any recommendations? Also, I do reload for my 9mm, .223 and 45 ACP...

Greetings Fellow Re-loaders: I hope that I do not bore you nor make you nuts with my basic questions here. But while cleaning my .223 brass I found a difference in the primer pocket of some of the brass. Most of the brass have a nice clean primer pocket with nothing out of the ordinary. While...

Greetings to All; I'm still new to the entire reloading venue. Up until now I have only reloaded for my 9mm, only about 2000 rounds so far. I feel pretty confident with my 9mm reloads. But now, I am going into new territory: .223 :confused: So, I have my Hornady Lock-n-Load Press set with...