Search results for query: *

My uncle has a Golden State Arms Santa Fe 30-06 he hasn't shot in roughly 10-15 years. I asked what it would take for him to part with it. The stock is junk and the scope isn't any good either but neither of us know what it is worth. Anyone know what they're worth?

:banghead: The LGS is getting pretty limited on powders and Hodgdon doesn't show RL-17 on the data base but barnes does. Barnes website also shows a lot higher velocities than the Hodgdon site. What gives?

I cant seem to find any actual data using a 405 gr cast boolit and reloder 7. I have seen where it has been used but not with published data from a reliable source, I would rather use actual data than go by what someone has posted on handloads.com if you catch my drift. any input/ help would be...

I purchased some 350 gr Speer softpoints and a can of reloder 7. Alliant list's a trapdoor load at 35 gr. Is that a start or a max load. I am shooting this in a rossi Rio Grande 45-70

I've loaded some 80Gr Barnes TTSX for my Marlin Xl7 25-06. They shoot roughly half inch 3 shot groups at one hundred yards. My only problem is I don't know the exact speed they are coming out due to the Marlins 22" barrel. The load is 54.4 grs IMR 4350 80 gr Barnes TTSX If anyone could...

I cannot find many reviews or much data on the Sierra's 70 Gr Blitzkings. I'm thinking about giving them a try any helpful comments are appreciated.

H-335 Being the only powder I had suitable for the job I loaded it with my 405 Gr Cast Performance WLNGC's for .45-70. Anyone have any idea the velocities I am getting with 48 grs of powder? And if it will be a sufficient deer killer?:confused:

The rounds I have made are within length but when I open and close my bolt it is either very difficult to close and open or impossible to close the bolt. :banghead:

Im new to handloading and know little to nothing about different powders. Also are any two powders the same.

My XL7 puts up .90 groups with 120gr Factory Cor-Lokts but Remington doesn't offer 120 gr Cor-Lokt components any substitutes or is there any place where I could actually find them.

I've always wanted a levergun in 45-70 and after reading many positive reviews I decided to get the Rio-Grande. Purchased it NIB on Nov.7 took it home and shot 325 Gr. hornady leverevolution through it at 70 yrds it would not hit the refrigerator my target was attched to. After moving to 50 yrds...

There aren't any hogs in my area of Ky and am looking to harvest some. I have heard about Larkin's Outfitters does anyone have any experience with them.

thinking of trading my "not very Handi Rifle" in 25-06 for a marlin x7 in 25-06 love the caliber just not so the rifle anyone have any positive or negative experiences with a marlin X7

This maybe asking alot but is their a certain 1903 you can / cannot shoot full power loads through

I'm new to handloading just wondering if you could use 30-06 dies to make 30-30 ammunition or vice versa and why or why not.

How are the new pardner single shot shotguns by nef im lookin at one with a 32 inch barrel

anyone have an opinion on the best scout mount for mosin nagants

Which is a better idea. A new barrel for my N.E.F. Handi rifle (223 REM) or a marlin xt-22 chambered in 22 WMR?

Anyone on the fence about buying priv patizan ammo for 25-06 and worried about quality it shoots as good if not better than 100gr remington cor-lokts

Ive recently picked up some 90 gr priv partizan hollow points(25-06) (velocity 3428fps) with some good penetretion (refrigerator door ) anyone have input on whether or not its good enough for deer hunting.