Search results for query: *

  • Users: chocdog
  • Content: Threads
  • Order by date
  1. C

    OCW - Getting my head around it

    Hey all, I have doing OCW's for my 30-06. So far I have completed the initial tests for 150, 165 and 180 SGK SPBT using RE15, RE19, RE22 and Varget. I have used On Target to plot my groups and I am trying to interprete the data. This is where I think I am lacking. According to what I have...
  2. C

    RCBS trimmer -case mouths not square

    I am using the RCBS manual pro trimmer and have issues with my case mouths not being square after trimming. I also have the 3-way cutter installed. After banging my head :banghead:about it I called RCBS. After explaining to their customer support guy that I bought about 2 years ago and before...
  3. C

    Soot on cases

    Hi all, I have this past weekend mad it to the range to perform a OCW test to develope a good target/practice load for my 30-06. The loads were using RE-19, SGK 150 SPBT, Federal brass and primers. The test went really well and it appears that for this combination the best node (grouped at...
  4. C

    Shoulder bump ---***?

    Can some one please enlighten me on the following. I am new to reloading and have measured, sized, trimmed.... about 400 case of 30-06 cases. Some were green but most were my own once fired brass. I measured the base to shoulder 20 random once fired case with the LNL headspace kit and...
  5. C

    Once fired brass

    When measuring shoulder length on once fired brass to set up my dies I am getting the following readings 2.040, 2.0405 and 2.041. All rounds are from the same rifle, cases are by Barnes and Federal and I randomly selected 20 rounds. Are these variances normal? Should I use the average as a...
  6. C

    Using Tru Oil - Help

    I am currently refinishing the stock on a old winchester 94. I am using tru oil and I am trying to get that last perfect finish coat. It never fails, just when I think I am ready for the sheen and polish I see fine ridges left. :banghead: I have followed the directions....thin sparse coat...
  7. C

    Pre 64 Winchester 1894 - Need Help

    I am trying to bring back to life my grandfathers Winchester 1894 in 32WS. From the SN it was built in 1910 and according to the paperwork, bought in 1911. I have disassembled the gun and cleaned all parts in my ultrasound cleaner. However, I would like to remove the RL cartridge...
Back
Top