General reloading question.
I process a lot of 45 acp in one sitting so it's ready for the range. I like to keep the brass between the max length and the trim to length, which I consider the minimum case length for headspace reasons.
I usually deprime dirty brass on a Lee single stage to keep...
I am beginning to load 45 Colt for a Ruger New Vaquero. All the data I see shows velocities obtained from a 7.5" barrel SAA. I would like to get about 850 fps from a 250 grain Hornaday XTP from my 5.5" barrel but max loads show 900 ish from 7.5" barrels. Any ideas on where to get data for 5.5"...
I've been looking all over for this information, but cant find it. Here is the question; at what size is .45 acp brass too short to reload safely ? I know nobody trims pistol brass. It only gets shorter as it gets fired. Manuals state .888 is minimum "trim to length" and .898 is max. Does...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.