Search results for query: *

  1. A

    Quality die for 1/2-28 ??

    It's time to buy a new 1/2-28 die, I ordered one from amazon as Brownels was out of stock. I went to use it to clean up threads on an AR because 3 threads about half way in had been hit at some point. The amazon die immediately felt like it was going to start cutting and not just thread on to...
  2. A

    How is this legal ?

    I've spent days searching forums and reading ATF regs and even purchased the Florida Firearms Law book from Jon H Gutmacher and I've yet to find an actual answer that is more than an opinion. My question is, if the overall length of a pistol is to be 26", fired by one hand and be considered...
  3. A

    S&W 6906 Grips

    I bought my 6906 new back in the 80's and still love it, hundreds of rounds through it and not one single malfunction ! My only problem is the factory grips, just too slippery if my hands have the slightest bit of moisture. I installed the Hogue wrap around on it, even though my hands are...
  4. A

    Ruger 44 Super Blackhawk parts ?

    Hi all, I need to find a hammer and trigger for a new model Super Blackhawk. Several places I've checked are out. Any suggestions ? Thanks!
  5. A

    Winchester 94AE 44 Mag Part Question

    I just got a 94AE 44 Mag and it's missing the right side (loading gate side) cartridge guide. Is there any difference for this guide regarding Angle Eject or Top Eject models ? The one pictured below states it's for a Top Eject... Thanks for any advice
  6. A

    Savage Model 67 series E Slide question

    Can anyone tell me if this part of the Savage 67 12ga slide is supposed to be welded on ? Looks like it was spot welded but on one I'm working on, it's completely separate. Pic is from Numrich's site. Thanks for any advice, Steve
Back
Top