Search results for query: *

My first time shooting a small frame pistol. Springfield Hellcat 9mm. Difficult to hold firmly because it is so small. Maybe that is my problem, not sure. I hold more firmly with my left hand to control the jump. Has anyone else shot a Hellcat or maybe the Sig365 , they have similar...

I never like using the digital caliper when measuring the cartridge length across the bullet ogive of my reload. While doing it, I never got the same reading. All my friends said its the same for everyone. You just get close to the same number and that the best you can do. Just could never...

I never like using the digital caliper when measuring the cartridge length across the bullet ogive of my reload. While doing it, I never got the same reading. All my friends said its the same for everyone. You just get close to the same number and that the best you can do. Just could never...

When should I anneal new brass ? Before or after FL sizing. ?

Im going to start tumbling my bullet with Moly coating. Friends tell me to wash them first in Acidtone. I know that will work. But I think the acidtone will deform a tipped bullet. I'm wounding if another would work also. Like denatured alcohol. Any suggestion on other choices. ?

Rem 243, 9 1/8 twist. I use the Hornady AOL guage to see what the seating depth would be. The Sierra 95 gn. bullet only seated in just a little ways past the Boat Tail. Im thnking ,,that's not good. Should have seated a lot deeper into the cartridge. So I got a fired cartridge that the...

After I annealed the brass, I couldn't use my flash hole deburring tool. The brass would not even go over the tool. The neck had shrunk. Should I run them threw the resizer again, but only letting the ball resize the neck ? Running the die only partway down into the brass.

I bought some once fired 308 brass from my local gun dealer. Just now starting to prep it. Man oh man, I cant seem to get the primer pocket reamed down to a level depth. I have always been able to easily just let my Lymen auto prep machine recut and ream the pocket much easier than this new...

I know what M.O.A. is when discussing the measurement, I think. My scope is one click is 1/4 in. so 4 clicks is one M.O.A. or 1" Right ? So that would be a 1" square, that is talked about shooting a good M.O.A. within a 1" square at 100yds. Then is shooting a Sub-M.O.A. shooting in less than...

Another question, I know. :) Copper Creek 243 DTAC ammo. And they are not the only one's offering this type. So what is it mean ? I'm thinking AR type. ?

I have been seeing this new ammo around lately. It really cheap. I'm wounding just how good it is. Is the brass any good for reloading. Has anyone shot this ammo before ?

Just getting back to reloading. I'm having a problem with the Rifle powder metering assy. It sticks when rotating, an only dumps a parcel load. And sometimes it works just fine. It stops because the powder is jamming when being dispensed into the rotor. I know this only because when I empty...