pardon me if this has already been asked and answered...
I’m trying to find reloading data for a Henry 45-70 (tube loader style) lever action rifle. I have been looking through my books and I see ruger (which I believe it too high pressure loads for my rifle) and I see marlin as well as...
so reloading .40 cal shot through a glock 23 with a wolf barrel
After shooting, de-capping and sizing (rcbs die..single die for both functions)
I get something weird
So I have a 8 in 1 Lyman case gauge I picked up from bass pro...
You see in the first picture the brass drops in just let...
hi everyone,
Question..I took some first reload up to the range and I am seeing some powder burning on the side of the cases (which I normally don't see with factory loads) and I am wondering if I'm either not crimping enough or maybe the charge isn't enough. I attached a picture of some .40...
hi all!..
So after loading about 30 round with my starting charge I apparently wasn't thinking and loaded berrys bullets (115gr flatpoint) come to find out they are lead...noticed that when I didn't flare the case enough on some testing blanks and it sheared off the side of the bullet..was...
Hi everyone...
i normally load 9mm and other rifle rounds, but I am going to start loading for my .40 cal pistol
I was wondering if someone could post me the load data for .40 s&w - i am having a hard time nailing down accurate load data.
I am using HP-38 (which i have been told that it is...
Hi everyone,
Doing my first batch of 9mm 115 xtp and I am wondering on the expander and crimp parts. I am using the RCBS die set and had a few questions...
how much should the expander be seated down into the case? I ask because I really can't tell or see the difference when I run the case up...
Hi all!
Does anyone have in their books a load for a
9mm luger
115gr XTP using the HP-38 (Hodgdon brand) powder
and also
115 gr FMJ using the HP-38 powder?
My manuals don't have the load out for them using this powder(Lyman and Hornady) and I see variance compared to what is listed on the...
Hello all.
Question, I trimmed about 150 cases with my lyman power trimmer and they are just slightly shorter than the top of the headspace gauge. Would you think it would be ok or should i trash the batch? When i say slightly shorter, i'm talking just slightly under the top of the top of...
I am new to reloading and the thought of having case separation on a reloaded round freaks me out.
So i have collected a good amount of brass that was ONLY shot from my 2 rifles (rem 770 30-06 and a savage 30-06). I have 3 different kinds, Hornady, Winchester, and PPU (which i think is...
hi everyone,
question for you experts. I have ventured into reloading and I am having a bit of an issue with my decapping/sizing die. I have the Lyman t-mag2 and am using RCBS 30-06 die set. I have adjusted the decapping pin to .25 extended at the end, locked it in. I have fully extended the...
OK, So i am new to reloading and new to the forum so please be gentle. I am getting ready to start reloading and I am looking for some advise on which bullet to use for a 30 06 reload.
I just got my Lyman Tmag press kit and I have been reading on the load that is needed. I will be reloading...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.