I am looking for a way to apply a finish that resembles fine sandblasting.
Thought of using flash rusting to cause fine pitting and then remove the rust but it seems too complicated.
Any ways to emmulate the look of a sand-blasted finish?
Just to mention that scratching with paper to cause...
Hi guys, I am trying to copper-plate my (in)famous revolver and then blacken the copper plating to make it look like it was blued. Don't ask me why, it's just an experiment.
I am using cold gun bluing for the job. It does blacken the copper plating but it leaves a very slight, still noticeable...
Hi guys, do you know of any good methods to remove rust from steel?
Yes, I know about rust removers. They all require the use of a wire brush and that's exactly what I am trying to avoid.
I need a chemical or something that would take the rust off the steel surface without the need of any...
Hi guys,
I am trying to restore a revolver that was heavily rusted.
I scraped off the rust with a soft rotary brush and now the surface is rust free but there are thousands of rust pits all over it.
Here is a photo of the surface. Some of the pits are qute deep and wide in diameter...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.