Search results for query: *

I have factory black rubber grips on my Kimber 1911. I took them off to clean the gun and found them sticky on the insides of the grips. This stickiness is probably from some gun oil sitting in there. I tried to wash them in warm soapy water and also tried wiping them with a little Hoppes, but...

This will give you laugh, but it really shows that Joe does`nt have a clue about what he is saying. http://www.ijreview.com/2013/02/38482-humorous-women-take-joe-bidens-buy-a-shotgun-advice/

Are lead bullets that are casted from bullet maker`s ready to reload? Do they have to be lubed and sized? Are they already lubed and sized?

I am making goose jerky as I write this. :) I`ll let you know how it tastes later. This is the first time I made it with goose. I mostly make it with deer, once with Buffalo. They were always good. :)

and other single shot handguns. I onced browsed through a forum that discuses T/C`s and XP100`s as well as other topics. I did a google but I have not found it. Wish I bookmarked it. Does anyone know what this forum might be that I am looking for? I think the person that runs the forum is...

My dealer is sold out on the Hornady Handbook Vol. 7. I want the charge data for 9mm and .357 Magnum handgun loads. For 9mm; Bullet: Hornady 115 gr. FMJ Powder: Bullseye Please post the minimum to maximum charges for this powder only.(The 4to 6 charges for this...

I have been shooting and reloading for 25 years now. For 25 years I have never bought, or shot a semi-auto pistol until now. So I am learning about these John Browning 1911 designs. There is always something new to learn about. I would like to know what is the differences between a Series 70...

What book would you say has the most comprehensive coverage on disassembly, troubleshooting, repairing, and caring for the 1911 style pistols all in one book. Looking for a book that would cover everything there is to know about the 1911 in one book, especially for troubleshooting.

How do you tune extractors on 1911`s? I have a Kimber Stainless TLE II in .45 ACP, and the brass gets a pretty heavy ding in the middle of the case. See this thread. http://thehighroad.org/showthread.php?t=291468

I have some .45 ACP brass that have been fired only once. They were factory loads. In the middle of the cases, some cases have heavy dents and some have slight or no dents. What causes this? I think it is the ejector. Will these dents cause reloading die problems? Or other problems? Do you...

I just got this email alert from GOA. http://www.gunowners.org/activism.htm In it it says that the Dems and the NRA are working up a deal to expand the Brady Bill. Now I know this has been a long discussion about the NRA compromising with them, but nowhere can I find info on this...

http://kevxml2a.verizon.net/_1_259VTO104L7BNOW__vzn.isp/apnws/story.htm?kcfg=apart&sin=D8ONTTQO0&qcat=entertain&ran=15997&passqi=&feed=ap&top=1

for the .45 auto? I can`t remember what it was, and I can`t find it in the glossary`s. I must be getting senile now. :uhoh: