I have a 1911 45 acp Rock Island Army. worked fine and shot good groups when I bought it. It has started now to lock the slide back when fireing. ie Fire two rounds and still five in magizine. have to push the slide lock lever to drop the slide to continue fireing. I might get off one or two...
I have looked in all my reloading books and can not find a load for 40 cal LFP, 180 gr bullet. Any help where else to look? I am wanting a light loat for target practic...
I have a GLOCK and a HK. Barrel changed to long wolf in glock. I would like a load for target shooting. I have titgroup, vihtavuori N320, and Clays pistol powder.
I will be loading 180 gr SWC........
I need some help on loading 9mm with 125 Precision Black Bulled, with either TG or VV-N320, also 40 S & W 155gr with TG or VV-N320 powder, and suggestions, Fred:banghead:
I have a S & W mdl 41 with a Weaver mount, and Bushnell Throphy red/green Dot Scope 30mm, WHAT quick disconnect Rings are suggested for this combination? I know where a pair of Weaver 30mm 49121 low mount rings are, jwill these work? I have tried the Weaver 49121 around the scope and there is...
I have been asked to get into BullysEye shooting, and need a 22 pistol for that. Looking for any suggestions. I have heard that the Smith & Wesson 41, and Ruger are a good choice, Thanks, Fred
I have been loading Rainer 124gr HP with vv-320 4.1gr, cartiage OAL of 1.125, and Chroneyed at 1044 fps.
I bought some Berry 124gr HP loaded with vv-n320 4.1gr and cartiage OAL ( had to seat bullet to 1.055 to get it to chamber), and Chroned at 1088 fps.
Question? is it common for one brand...
While shooting today I had 4 failure to eject rounds while shooting a match. No problem release magizine clear chamber and reload mag. and keep shooting.
What would have caused the problem? I was shooting a S&W 5906 reloading Rainers 124gr over 4.1gr vv-n320 winchester primers ( pistol )
Any...
I understand that the Dillion Case Gage is used to give the reloader a GO or NO GO if the reloaded round will chamber into the barrel, IF I AM WRONG PLEASE HELP. I have had a problem with the Berry 125gr HP not chambering in my S&W 5906 seating the bullet with a OAL of 1.125, I had to keep...
I understand that the Dillion Case Gage is used to give the reloader a GO or NO GO if the reloaded round will chamber into the barrel, IF I AM WORNG PLEASE HELP
I finished reloading 9mm Berry Mfg 125 gr HP with V-N320 and set the OAL at 1.130, Trouble is they would not chamber?
I had to Keep seating the rounds all the way down to 1.055 OAL to get the round to seat in the chamber. there is still just a little room left to seat this bullet th that OAL...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.