Search results for query: *

I recently removed crimps from some .223 brass with a coutersinking drill bit. I only cut off enough to allow for primer seating and all the primers seemed to seat pretty snug. I did notice however that now it looks like the case is chamfered around the primer. Do you guys think this is cause...

I just finished loading a batch of .223 rem and noticed that about 50 cartridges out of the 300 don't seem to have been fully sized. I noticed that the necks of these cases only show marks from my lee dies about halfway down the neck. I don't have a case guage but was wondering if anyone has...

Any ideas why my handloads for my Smith and Wesson MP 45 won't go into full battery at least once for every mag loaded. I am loading 230 LRN over 7.0 gr of HS-6. Thanks in advance

Is it normal to have a bolt that is harder to close if using fire formed brass. I just started reloading for my .308 Howa 1500. I set my Lee die to neck size by leaving a gap about the thickness of a penny between the die and the shellholder. The sizing marks on the neck cover tabout 2/3 of...

Just picked this up. Range report to come. Howa M1500 Tactical chambered in .308 win. Picture quality sucks but you get the idea.:)

I just purchased a Howa M1500 Tactical chambered in .308. I was wondering if someone could tell me if this is considered long or short action. I am assuming its a short action but we all know what happens when one assumes. I am looking to upgrade to a bell and carlson medalist...