I read that lead dust is a concern and care should be used when tumbling and using the media separator when cleaning brass.
I can see how that could be a issue is shooting non jacketed lead bullets but if they are jacketed is that really a concern ?
I ask cause i have kids and i don't want...
i have a set of 2 RCBS dies but have been considering the LEE delux 3 die set.
but reading it says with the collet neck sizing die you get more accuracy but harder to chamber which may be fine with bolt actions but i am left wondering how about semi autos?
I shoot a browning BAR .300wm...
i got some .308 surplus ammo that was removed from belts so some of the bullets are seated a little crooked hard to notice unless you roll them them you can see them wobble
they are all seated tight and i will be using them in a cetme (direct blow back semi auto rifle)
has any one else...
i got a older iver johnson.32 S&W that was designed using black powder loaded cartridges.
can lower pressure or black powder loaded ammo be found commercially for it
since i don't reload, is there any collectors value for it cause if it cost too much to shoot i'm going to trade it off...
Hello
A buddy of mine has a winchester model 88 .308
last hunted with it 6 years ago and it has sat uncleaned eversince
he took it out to hunt this year and it has some ejection and feed issues nothing serious
I'm thinking a real cleaning should solve the issue so if we remove the...
i got a call from my cousin this mourning said he was chambering a round and as he was locking the bolt it got half way and got stuck he can't open it to extract the round and he can't close it to finish
he did not want to tap it with a hammer out of fear that it would go off
does anyone...
i hope i'm asking this and explaining it correctly
when there is no round in the chamber and the bolt in not fully closed but just closed enough to keep bolt from falling back, when the trigger is pulled the bolt closes and locks but the cocking pc does not slam to fire and is unable to...
i want to replace the dark barrel in my nagent and came across a guy who has a barrel (still attached to the receiver and trigger group )for $10
the guy said there is a hole where someone had tried to mount a scope mount on it and drilled all the way into the tail end of the chamber
i...
well i have done research on this and found that bulgarian should be avoided in Cz 52s i know that there has already been lots of discussions on ammo issues in Cz52s but what i can't find is a list from hottest to least hottest surplus ammo.
i would like to use the one with least pressure...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.