3d print

Hi All, I've been a quiet lurker for a while and thought I'd make a post just to contribute. Anyone who shoots and reloads .45 ACP is very well aware of the cursed small pistol primer cases that seem to pop up regularly in range brass, and even in the stuff we buy. In addition to eyeballing...

I found this on youtube and bought the 3D printer files and I can say that it is a great improvement over the Lee unit. You can buy the complete printed kit or the 3D printer files from the designer. He is very responsive and made a slight improvement after I contacted him. I am not affiliated...

Hello. I just 3D-printed a loading lever clamp for my 1851, to prevent the lever from dropping under recoil when using heavy loads. It sure looks goofy but should work fine. The file is on Thingiverse: https://www.thingiverse.com/thing:6112897

Lately I've been hearing a lot of praise for the Ender 3 3D printer. However, I really don't want to buy my 3D printer from a chinese company. Does anyone know of any good 3D printers for gun builds similar to an Ender but not form a chinese company?

Hi Guys, I got so much from this forum in the past so I am glad to finally give back. I just want to share a solution for a problem to address the cylinder pin lock on an 1858 Remington in case that the loading lever is removed (not used) anymore. I can imagine 3 major cases for that: - to...

Thought this was pretty crazy, being that I am an advocate of 3D printing, particularly guns :) This Canadian man has 3D printed almost an entire rifle modeled after a Ruger 22. What do you guys think? http://3dprint.com/31807/3d-printed-rifle-from-canada/

This 25 year old kid has created special bullets which work in even the cheapest of 3D printed plastic guns. It's basically a shell which buffers the cheap plastic from the gunpowder and actual bullet inside... http://3dprint.com/23119/bullets-3d-printed-guns/