rmrbullets

Hi wondering if anyone has good load recipes for hp38 for 45 acp. The components I have on hand are RMR 230gr fmj, new starline brass and cci 300 primers as well as remington 2 1/2 primers. I was also curious about the interchangeability between these two primers. I'm looking for ball spec...

Did a retest on my 357sig load using Herco and RMR 124gr MW, 1.140" OAL, Shot out of my 1911 72F, wind 10-15 to my back This little sig round pack a punch. My Ransom rest was tilting back so far it was not auto reset. I had to give it a nudge to go back down. Starling Brass (new, resized) WSP...

This is a continuation of the WSF test using WST. All shot using my Ranson Rest that I built. All these loads self reset after each firing. All I had to do was pull the string every 5-10 sec. Shot out of 1911 that I built, Kart barrel. Temp upper 60's, Wind 10-15 at my back. WST , Dispensed...

Shot some test loads yesterday using my new home built Ransom rest. I did make a slight mod and moved the remote trigger bar downward, so brass ejection does not hit it. I attached my rest using a single 5/16" x 2.5" lag screw into my bench in the front, and c-clamp at the back. This position...

I have been searching the internet for days and i have not been able to find any reloading recipes for federal bullets. While federal bullets are not sold new as components, they are sold as pulled demilitarized or old stock. I purchased some federal hi-shok and hydra-shok for plinking before I...