308 LC Brass and Ramshot Tac

[JO JO]

anyone use Tac with 150gr btsp and LC brass, I know I need to reduce for the
LC Brass, The brass is new unfired, so my question is since I do not have a chrono I curious if anyone has used this combo ?
I went to the range today with some loads to try and found that 42.0 and 42.3
grains of TAC did well for me at 100 and 300 yards brass ejected fine and looked fine , would these be considered mid or upper load range using LC 7.62 brass ? Shooting a Savage 11 Hog Hunter
Thanks

 

[Walkalong]

Copied form the Western Powders 6.0 PDF.

150 HDY SST 40.7 2,709 45.2 2,943 61,830 2.735
150 HDY BT-FMJ 40.8 2,723 45.3 2,957 61,835 2.735
150 NOSLER A-BOND 40.0 2,675 44.4 2,907 61,523 2.810
150 SIERRA SBT GK 40.7 2,714 45.3 2,951 61,884 2.750
150 SPEER SPZSP 40.2 2,672 44.7 2,900 61,729 2.700
150 BARNES MRX-BT 40.8 2,697 45.4 2,938 61,881 2.785
150 NOSLER E-TIP 38.9 2,591 43.3 2,830 61,333 2.810

I'm not sure what brass they used, and Military .308 is a normally bit heavier than commercial, but it looks like your fine.

Hopefully some folks more experienced in using LC for .308 will chime in.

 

[JO JO]

I guessing this is an unpopular combo ?

 

[CarJunkieLS1]

I use TAC in my 5.56/.223. If they did well for you at 100 and 300 yards, why push them faster for potentially no benefit. Either way if you aren't getting pressure signs then you could always go up .3-.5 grains at a time to find the max for your rifle.