Stormin.40
Member
- Joined
- Feb 17, 2011
- Messages
- 477
I am going to start loading .38 special and just purchased a set of RCBS Carbide dies. The are not labeled RC or TC and I was told that these dies will do both taper and roll crimp.
How to you determine if you are roll crimping or taper crimping, it is not stated in the instructions? My assumption is that a light crimp would taper and a heavier crimp would then roll.
I plan to load LSWC first and would like to roll crimp but would like to load some plated down the road and want to taper these.
How to you determine if you are roll crimping or taper crimping, it is not stated in the instructions? My assumption is that a light crimp would taper and a heavier crimp would then roll.
I plan to load LSWC first and would like to roll crimp but would like to load some plated down the road and want to taper these.