Peakbagger46
Member
- Joined
- Jan 1, 2009
- Messages
- 1,479
I just started reloading for my glock (a gen 3 27) a couple of weeks ago. I've noticed the bulge toward the rear of the case does not go away when full-length resized through my RCBS carbide die. After about 4 firings, a few of the cases were hard to resize and exhibited a bright abrasion ring about 2/3 of the way down the case. I threw these cases out but I'm still a bit concerned with the fact that most all of the brass is bulged after resizing.
They do all fit in my glock chamber after being resized, and I am not using hot loads. Should I maybe get an aftermarked barrel with more support just to be on the safe side?
They do all fit in my glock chamber after being resized, and I am not using hot loads. Should I maybe get an aftermarked barrel with more support just to be on the safe side?