dmftoy1
Member
Hi, this is probably a stupid question, but I'm considering getting back into reloading again after being out of it for about 15 years. I'm looking at a used Dillon press like the one I used to have, and the guy says it's setup for .45lc and .45acp. I only see dies for .45acp, but I do see a calibur conversion kit for .45lc. Is it possible to use .45acp dies to load .45LC? I would think the crimp would be different?
Any and all advice is greatly appreciated.
Have a good one,
Dave
Any and all advice is greatly appreciated.
Have a good one,
Dave