I have been using a set of Lee .44mag dies in my new LNL progressive press. I found that to get the dies set properly I had to flip the jam nuts over to reach far enough down through the bushings. The O-ring on the bottom of the locking nut was keeping me from getting the dies to go deep enough. Now that the dies are set I only have maybe 1/2 - 1 thread of engagement on the locking nuts which I guess is OK as they are not holding any load just maintaining position against rotation. I am considering a set of lee dies for 223 to use in the same press but I'm concerned that they may exhibit the same trouble. If they are any worse I'd be sunk. Is anybody using Lee 223's in the LNL progressive? Any issues??
Thanks
Thanks