Anyone Use 135gr Jhp's in Thier 40s&w?

Status
Not open for further replies.

possum

Member
Joined
Oct 12, 2005
Messages
8,941
Location
Concord, N.C.
i was wondering becuase after reading a particular book and looking at various info the 135gr's have done really well. do any of you guys use 135gr rds. i normally use 165gr xtp's or 180gr, but bought a box of 135gr hydra-shocks today. thanks.
 
I've found that most 135gr .40 is louder, shoots a bigger ball of flame, recoils snappier and is less accurate than your typical 165gr stuff.

Its fun to shoot but 155gr and 165gr probably have a slight edge on actual stopping power.

Most of the scuttlebutt out here on the net (FWIW) seems to suggest that 155-165gr is the "sweet spot" as far as .40S&W loads go.
 
My friend uses the Hydra Shock load in his G27 because he says he can control it much better than the 155 grn Rangers he had before.
 
the hydra-shoks i picked up today said they were reduced recoil, and i thougt this might be a problem but on the back it says it has a muzzle velocity of over 1150fps.
 
I have used them. Has the usual extra "fireworks" out of the muzzle of the various defense rounds. slightly more snappier than typical range FMJ rounds that I have noticed in the 165 or 180 gr flavor.
 
High velocity + expanding bullets are impressive in actual usage.

They seem to have a quality that isn't measured in the regular gello tests.

My choices for defense ammo for 9mm is the Federal 115 grain +P+ at 1300fps, and .357 magnum it's the Federal 125 JHP at 1450 fps. If I were to use a .40 I would be carrying 135 grainers.
 
,40 Loads?

I'm from the same school as a poster above, if the 125gner in the .357 set all those standards then a 135gner at a bit over 1500fps from the ole G-23 oughts do the job!
Unofficial testing in the woods confirmed my suspicions,,,yup!
 
Status
Not open for further replies.
Back
Top