Keeperfaith
Member
- Joined
- Dec 30, 2010
- Messages
- 235
I built my own AR. The gas block is a DPMS railed gas block which utilizes set screws to keep it in place. The first time I shot the rifle it functioned flawlessly. The next time I shot it the bolt never cycled back to eject the spent case. I noticed the gas block had came loose so I knew there was no gas coming through. Ok no problem, I went home, put the gas block in place and tightened the set screws w/ lock tite.
Went to shot it today and AGAIN, it won't cycle but The gas block is tight.
Any suggestions?
Thx
Steve
PS: the first time I shot it, I only shot about 30-60 rounds, cleaned it thoroughly and put it away.
Went to shot it today and AGAIN, it won't cycle but The gas block is tight.
Any suggestions?
Thx
Steve
PS: the first time I shot it, I only shot about 30-60 rounds, cleaned it thoroughly and put it away.