Ar10 build

Status
Not open for further replies.

Jqcon24

Member
Joined
Dec 7, 2021
Messages
4
I recently decided to build an ar10.
I have built ar15's before but never an ar10. I plan on using a 20 inch barrel and was trying to figure out what twist rate I should use. I'll be using a .308 caliber setup. Any suggestions would be great and any other recommendations would help to.
 
Thank you gentlemen for replying. I plan on using between grain 155 to 168. I want to use the rifle for long range shooting.
1:10 twist ratio seems the way to go. Thanks.
 
I used a 20” Ballistic Advantage 1-10 barrel, and have gotten to 900 yards(longest distance available)with 168 and 175 grain SMK. This particular barrel didn’t like 150 grain bullets at all.
 
I recently decided to build an ar10.
I have built ar15's before but never an ar10. I plan on using a 20 inch barrel and was trying to figure out what twist rate I should use. I'll be using a .308 caliber setup. Any suggestions would be great and any other recommendations would help to.
I like my 18.5" MP10. I wouldn't want anything heavier for walking use. I walk a few miles at a time when deer hunting. Most (All) 20" AR10s I know are pigs. When I say Pig, I mean @ over 9lbs scoped with a loaded mag. My 16" Armalite AR10 (Mark Westrom Pre forward assist) feels like the MP10 but is a 16". It is chrome lined, and sub moa accurate for three shots on a cold barrel. Or even a warm barrel. And that is with a Redfield 2-7 scope. But it carries and balances well. IIRC it is 1:11 twist while the MP is 1:10. twist. They are on the left. 28252.jpeg
 
Status
Not open for further replies.
Back
Top