Have you tried driving the pin from the retention retain side using a tapered punch? This may help to iron out the retention so it can move that direction.
Have you tried driving the pin from the retention retain side using a tapered punch? This may help to iron out the retention so it can move that direction.
No I have not because I do not have one in my workshop. However I am going to check my garage tomorrow. The hole is so small (again, 1mm or approximately 0.040") that I don't even think I have anything that small. But I will check my garage tools tomorrow like I said. Thanks.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.