OrangeCat
Member
- Joined
- Mar 24, 2019
- Messages
- 407
Tried seating bullets last night and this was the end result.
Obviously I set the die much lower than I thought. I tried setting it to where it touched the case mouth and then back up a quarter turn higher but everything I tried to fix it seemed to exacerbate the problem.
Any helpful tips anything I should be feeling for. Can I salvage anything from these or should I just kill the primers and chalk it up to learning experience.
The case furthest to the left looks okay and the one next to it is a little bit 'dimpled' just below the shoulder.
I'm using a Lee challenger breechlock and rcbs dies
Obviously I set the die much lower than I thought. I tried setting it to where it touched the case mouth and then back up a quarter turn higher but everything I tried to fix it seemed to exacerbate the problem.
Any helpful tips anything I should be feeling for. Can I salvage anything from these or should I just kill the primers and chalk it up to learning experience.
The case furthest to the left looks okay and the one next to it is a little bit 'dimpled' just below the shoulder.
I'm using a Lee challenger breechlock and rcbs dies