aliasneo07
Member
Hey guys.
Recently I was attempting to install an ATI AR-type stock on my mossberg 500. Long story short, I used an incorrect bold, overtightened it, it protruded into the receiver, and broke off part of the connector in the trigger assembly.
End result-- no safety.
Question is...I can order the connector from brownells for like 5 bucks. How hard is it to remove the broken one and install that one? Has anyone done it before? Is it impossibly for an average joe, and I should just buy a new assembly?
Thanks in advance.
Recently I was attempting to install an ATI AR-type stock on my mossberg 500. Long story short, I used an incorrect bold, overtightened it, it protruded into the receiver, and broke off part of the connector in the trigger assembly.
End result-- no safety.
Question is...I can order the connector from brownells for like 5 bucks. How hard is it to remove the broken one and install that one? Has anyone done it before? Is it impossibly for an average joe, and I should just buy a new assembly?
Thanks in advance.