PinnedAndRecessed
member
- Joined
- Aug 10, 2004
- Messages
- 1,541
I seem to remember a case trim die where the case mouth protruded out of the end of the die. Then you were supposed to take a file and trim it down. Does anybody remember such a creature?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Case trim die.
- Thread starter PinnedAndRecessed
- Start date
- Status
-
Not open for further replies.
highlander 5
Member
it's called a file and trim die I used one to make 40/65 brass from 45/70 brass it was a bit of a PITA but it beat the hell out of trimming 1/8' with a rotary trimmer.
When reforming brass from a large caliber to smaller they stretch and sometimes quite a bit and I had to do this for 100 cases. And of course not long after this starline made brass and PMC had loaded ammo.
When reforming brass from a large caliber to smaller they stretch and sometimes quite a bit and I had to do this for 100 cases. And of course not long after this starline made brass and PMC had loaded ammo.
- Status
-
Not open for further replies.