I seem to remember a case trim die where the case mouth protruded out of the end of the die. Then you were supposed to take a file and trim it down. Does anybody remember such a creature?
it's called a file and trim die I used one to make 40/65 brass from 45/70 brass it was a bit of a PITA but it beat the hell out of trimming 1/8' with a rotary trimmer.
When reforming brass from a large caliber to smaller they stretch and sometimes quite a bit and I had to do this for 100 cases. And of course not long after this starline made brass and PMC had loaded ammo.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.