Mousegun
Member
- Joined
- Dec 9, 2005
- Messages
- 738
I have read a lot about removing the crimp in 556 brass before priming.
Can someone explain a bit about the actual crimp itself? Is it the full length of the primer? Is it just at the top portion like the crimp on a bullet?
I know there are tools that remove the crimp but can a drill bit be used successfully?
Thanks for any response.
Can someone explain a bit about the actual crimp itself? Is it the full length of the primer? Is it just at the top portion like the crimp on a bullet?
I know there are tools that remove the crimp but can a drill bit be used successfully?
Thanks for any response.