CZ 452 trigger mod

[Oldnamvet]

My CZ 452 trigger was fairly heavy and had some creep in it. Rather than replace the trigger assembly, I tried one of Eric Brooks' cheapo (in cost, not quality) kits. It took 20 minutes to install and sure makes a world of difference in the trigger. No creep and lets off consistently at 2 lbs. I won't be able to blame any bad groups on the trigger anymore.

 

[kel]

Can you tell me how you got the staked pin in and out? I want to put the springs and tube in my gun, but I can't figure out how to remove it and then put it back in.

 

[acdodd]

I also installed Brookes kit.
The pin will drive out pretty easy. Make sure you use the correct size punch.
I tried different combinations of sleeves and springs until I got it where I want.
Go ahead and do it. You will be surprise how much better it is.
AC