spencerhut
Member
Shot two different CZ Bren 2Ms firearms today and both exhibited poor accuracy, 3 to 6 MOA.
1. 16" Carbine with Sig Tango4 6-24x
2. 11" Pistol with Trijicon Accupoint 1-6x
Also shot a Keltec RDB Survival with a Trijicon RMR 1x and one of my 18" AR's with an off brand crap scope on it at the same time to sanity check the accuracy I was getting out of the CZ's and my ammo. To my shock and horror the Keltec got ~1.5 MOA and out shot both CZ's with ease with a freaking RMR . . . so did the AR at ~1MOA.
Ammo was factory 55g fodder, 62g Green Tip & 75g Hornady match. Also shot some of my known good hand loads, 55g Nosler FB-BT & 70g Berger
Same ammo was used on all four guns.
I stopped and cleaned all four barrels, checked each with a borescope to make sure they were clean and there were no obvious defects. All looked just fine.
Shot them all again. Same results.
Anyone else have poor accuracy out of a CZ Bren?
1. 16" Carbine with Sig Tango4 6-24x
2. 11" Pistol with Trijicon Accupoint 1-6x
Also shot a Keltec RDB Survival with a Trijicon RMR 1x and one of my 18" AR's with an off brand crap scope on it at the same time to sanity check the accuracy I was getting out of the CZ's and my ammo. To my shock and horror the Keltec got ~1.5 MOA and out shot both CZ's with ease with a freaking RMR . . . so did the AR at ~1MOA.
Ammo was factory 55g fodder, 62g Green Tip & 75g Hornady match. Also shot some of my known good hand loads, 55g Nosler FB-BT & 70g Berger
Same ammo was used on all four guns.
I stopped and cleaned all four barrels, checked each with a borescope to make sure they were clean and there were no obvious defects. All looked just fine.
Shot them all again. Same results.
Anyone else have poor accuracy out of a CZ Bren?