Tn Tom
Member
I have a .357 mag I bought used with no history. It has an 8" barrel. It is a Monsan 150xxx S/N so Im calling it a 15-2 from some earlier research.
I bought a 4" barrel assembly (not a porkchop shroud neither is my 8"). When I set my gap at .006" then slip on the shroud the barrel does not extend far enough into the shroud by about 3/8 of an inch, no threads showing.
Im thinking the assembly might be for a smaller frame if there is such a thing. Can anyone put some insight into this. Is there a "Small frame" .357.
I bought a 4" barrel assembly (not a porkchop shroud neither is my 8"). When I set my gap at .006" then slip on the shroud the barrel does not extend far enough into the shroud by about 3/8 of an inch, no threads showing.
Im thinking the assembly might be for a smaller frame if there is such a thing. Can anyone put some insight into this. Is there a "Small frame" .357.