greyling22
Member
so I have a fairly new to me dillon 650, and I've been experiencing a few teething problems (most of them are all my fault, but I don't think this one is)
I bought the press set up for 357. I loaded about a thousand of them with virtually no problems, then switched to 9mm. My cases aren't directly under the dies. Now, it's close, and usually works, but I get about 1:50 the lee powder through die catches the rim of the case and crumples it. So I started lookign closer at the rest of the stations, and they don't quite line up. The primer doesn't come up through the center of the hole in the plate, the seating die is slightly off, it's all just slightly off. Like 1 or maybe 2 degrees off if you were looking down at the shellplate from above. it's like it is not quite rotating far enough, thought the shellplate is sitting solidly in the detent. Is the carrier adjustable like it was on the loadmaster?
I bought the press set up for 357. I loaded about a thousand of them with virtually no problems, then switched to 9mm. My cases aren't directly under the dies. Now, it's close, and usually works, but I get about 1:50 the lee powder through die catches the rim of the case and crumples it. So I started lookign closer at the rest of the stations, and they don't quite line up. The primer doesn't come up through the center of the hole in the plate, the seating die is slightly off, it's all just slightly off. Like 1 or maybe 2 degrees off if you were looking down at the shellplate from above. it's like it is not quite rotating far enough, thought the shellplate is sitting solidly in the detent. Is the carrier adjustable like it was on the loadmaster?