Sebastian, I tried the 9MM 124 Golden Sabers in one of my always reliable 9MM pistols. It became an instant jammamatic with the Golden Sabers. Golden Sabers must work fine in many other pistols since I have little doubt that Remington sells all they can manufacturer. I've shot a fair amount of the "old tech" Remington R9MM6 9MM 115 grain +P JHP and Remington R45AP2 .45ACP 185 grain non +P JHP issued by our local police dept. Only gripe I have with these is that they are VERY high flash in low light. Both do feed reliably though. Just a comment about the #1 1/2 primers Remington sells, and apparently uses in some of it's factory pistol ammo. This primer seems more prone to piercing that any other American made primer I've used. They are the only factory primers I've had pierce in standard pressure 9MM factory ammo. Remington UMC-115 grain standard pressure ball for instance. Different lot numbers occasionally used in a variety of 9MM pistols and revolvers over a period of years. I've also had primers pierce when using the Remington R9MM6 115 +P 9MM in different guns. I don't know if the 1 1/2 or 5 1/2 primers are used in Remington 9MM +P ammo. I used Remington rifle, pistol and shotgun ammunition, primers and other components with no issues for many years. I no longer buy Remington ammunition or components.
BTW, I've used a fair amount of the Federal 9BPLE 9MM +P+ ammo in pistols, revolvers and carbines. Never any issues at all. I would prefer the old, low tech, 9BPLE over any of the Remington 9MM ammo for duty, carry,SD,HD, etc....ymmv