hornadylnl
Member
- Joined
- Dec 11, 2006
- Messages
- 375
I'm loading 25/06 using new Winchester brass and Hornady 100 gr. interlock spire point bullets. Min. overall length is listed at 3.2" and max is 3.25". If I seat to about 3.205 -3.21 the cannelure is about 1/8" or so above the case mouth. Is this okay or must the cannelure meat the case mouth? I'm guessing the cannelure was put on these bullets for a different 25 caliber round. I'm loading about 43.5gr of Varget so there is plenty of case room but I don't want to run into pressure problems by seating them to far. If the cannelure doesn't matter, than all is well. I'm planning on using Nosler combined technology 85gr ballistic tip bullets after I run out of these Hornadys. TIA for any advice.