Blue Brick
Member
Every time I consider buying a 44 Special, ammunition prices and ammunition selection bring me right back to the 38 Special.
I HATE monotonous reloading tasks, but I sat and loaded 100 .44 Special today simply so I dont have to spend 125 bucks on factory ammo. Ill probably load another 1-200 before i go shooting again. I Also run the Skeeter load in my Special, which is WAY punchier than the one locally available factory loading. Probably more than one would want to launch from a compact revolver.If you want to shoot 44 Special, you need to consider reloading.
Besides, if you have reloading capabilities, with proper planning you can get through ammunition shortages with no problems.
I HATE monotonous reloading tasks, but I sat and loaded 100 .44 Special today simply so I dont have to spend 125 bucks on factory ammo. Ill probably load another 1-200 before i go shooting again. I Also run the Skeeter load in my Special, which is WAY punchier than the one locally available factory loading. Probably more than one would want to launch from a compact revolver.
I had a progressive for a while, then a buddy expressed interest and i gave it to him with the understanding that ill buy all the components, he does all the handle pulling.....speaking of, i need to order him more bullets.I felt the same loading on a single stage press for 15 years. Then I finally ponied up and got a progressive and it opened up a whole new world of reloading, perfect for quantity and lack of time. I still use a single stage or manual turret press for those loads that require more precision.
‘Sorry to be presumptive here, maybe a progressive bores you just the same. But at least the payoff is a complete round with each pull of the handle.
I haven't started the reloading hobby yet either. I look back at all the guns I have bought, sold, and traded. The reloading hobby could have been an expensive one. I'm sure that the reloading would be fun, but lack of time is why I never started. Retired now maybe I will start.I am not a reloader.
A Lee Loader is my only reloading experience shortly after I purchased my first handgun, a P&R new S&W Model 13 shortly after I turned 21. Lots of mallet work on the shoddy kitchen floor in a sketchy rental duplex in a sketchy neighborhood back at that time & place in my life, but my roommate and I never experienced any break-ins.I don't think I have ever been bored while reloading, even on a single stage press. Now my first reloading experiences started with a Lee Loader and that could get a little tedious at times, especially with all that hammering going on with a rubber mallet! But I always get a kick out of making my own ammo because 1) it saves money, and 2) I can "customize" my loads to whatever I want them to be, at least as long as the reloading manual says it's okay to do it!
I've got a Lee Loader for 44 Special.....
No, not difficult at all.Is it very difficult to "seat the primer"? (If that is the correct terminology)
I understand the .38 Special. There are a lot of "pocket" revolvers chambered for the .38 Special. But there aren't a lot of .44 Specials floating around, so why all the interest?