I used the sanding drum on a dremel to remove the wording, then sandpaper and Scotchbite pads to even out the finish over the entire gun. Then finished with Flitz on a cotton rag to bring up a gleam.
How hard is it to replace a barrel on a Ruger? If it isn't too difficult, couldn't someone who hates the paragraph get rid of the paragraph and shop around for a relatively inexpensive spare barrel to leave the paragraph on it, then replace the barrel should they need to send the gun in for work?
I know, that is a bit much for an unlikely event. Either sand off the paragraph and don't worry about it, then should there be a problem pay a little to have it fixed,or if you are worried about it don't touch the paragraph.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.