GLOCK sights install

[j1979]

I just got my set of Warren Tactical night sights and need to get them put on. I myself dont have the tools to do it so I will have to bring it somewhere, probably the place I bought it. Is there anything to screw up, scratch, ding etc. that could happen by installing these?
Should I look for a good gunsmith to install them or am I just thinking about it waaay too much? Also anyone have these sight and do you like them? I did alot of reading and decided these were the ones I wanted. Thanks for any replies.

 

[CountGlockula]

You might as well bring it to a smith to install, because the front site may be a bit challenging. Whereas the rear sight you'll need to just hammer it out/in USING a small wood buffer between the sight and hammer.

I've heard good things about Warren. I have Trijicon night sights installed by Glock.

 

[thunderstorm]

All of the installations of the rear sight that I have seen has been with a site installation tool that has a threaded rod that presses the old sight out and the new one in, if you run into a smith that wants to use a hammer…….run the other direction!

 

[j1979]

I will probably just take it to the place I bought it. I would think they could do a good job and would have a GLOCK Armorer on staff