1911WB
Member
Anyone have experience with replacement 9mm SS extractors by Wilson, EGW, etc.?
Good quality SS 9mm/.38S extractors?
- Thread starter 1911WB
- Start date
- Status
1911Tuner
Moderator Emeritus
SS Brass Snatchers
Howdy WB...Sorry, I haven't. Somebody might have, but as long as this one has laid here unanswered, it might be a while in comin'.
Alternate method:
Sand the finish off the butt of a blued extractor and use it in the white. To
more closely match a beaded or matte finish, try different grits of sandpaper.
Lay it over the finish-removed end and rap on it with a plastic mallet. Might not match exactly, but it'll matte the shiny area pretty well...and if ya experiment a little, it might get pretty close.
Howdy WB...Sorry, I haven't. Somebody might have, but as long as this one has laid here unanswered, it might be a while in comin'.
Alternate method:
Sand the finish off the butt of a blued extractor and use it in the white. To
more closely match a beaded or matte finish, try different grits of sandpaper.
Lay it over the finish-removed end and rap on it with a plastic mallet. Might not match exactly, but it'll matte the shiny area pretty well...and if ya experiment a little, it might get pretty close.
JeffC
Member
Saw your question at 1911forum too, for stainless extractors I'd go with Caspian.
www.caspianarms.com
www.caspianarms.com
- Status