H Koon, snakecharmer

["kickin in yuma"]

Hi I'm looking for any available instuction on the assembly and dis-assembly of my H. Koon .410 snakecharmer shotgun, any info would be appreciated
"kickin in yuma"

 

[rcmodel]

It's just a single-shot shotgun.
It can't be that hard.

You will not find anything specific for the Koon Snakecharmer, but it isn't very much different then any other single-shot shotgun.
http://www.gunpartscorp.com/catalog/Products.aspx?catid=9294

Why do you need to take it apart?
If it isn't broken, don't fix it.

rc

 

["kickin in yuma"]

koon shot gun

Problem is the main pin came out while it was is a soft case and the whole gun was in pieces, I know there's only one spring but haven't been able to figure out how everything fit's back together, any suggestions?
thanks-"kickin in yuma"

 

[bent9]

Snake Charmer Assembly

Did you get any response? I have to get one back together and am having problems.

Bent 9

 

["kickin in yuma"]

bent9, no nothing yet, good luck -kickin in yuma

 

[Rail Driver]

If you go to the link rcmodel posted and you study the picture for a couple minutes, it shows where and how the parts go together. Your parts may be slightly different, but they will be similar enough (and only fit together one way) that you shouldn't have any problems.

If you're still having problems after studying the blown-out parts schematic, then lay out your parts like in the picture, take a photo and post it here so that myself or someone else can walk you through it step by step.

 

["kickin in yuma"]

snakecharmer

Raildriver- here are two photo's of the gun, can anyone help to explain how they go back together. Are there any special tools needed? thanks -kickin in yuma

 

[Rail Driver]

Lemme see what I can find. It'd be easier if I had the parts in front of me and could see them from all angles. I'm not going to be able to give you a step by step just from the picture, perhaps someone that knows these guns better can help more or sooner than I can.

 

[[email protected]]

Hello, hope this is not too late: most elements require purchase of manuals, however this link will get you what you need to disassemble or reassemble the snake charmer.

If it does not work, simply google and it will give you a list.

http://books.google.com/books?id=zR...shotgun assembly&pg=PA416#v=onepage&q&f=false

 

["kickin in yuma"]

Thanks for the info, i've been looking for info on the snake charmer for a long time! I ordered the book which from the review of it should help me get the gun reassembled-thanks again,kickin in yuma