brewer12345
Member
- Joined
- Nov 29, 2015
- Messages
- 2,751
I am gathering up the stuff I need to shoot cowboy type loads through an 1858 with a conversion cylinder in 45 Colt. I have found brass and dies, already have primers and Trail Boss. I do not have any purpose made molds for 45 LC, just 45 ACP molds. I was planning on trying a modest charge of Trail Boss and the Lee copy of the HG 68 bullet, a 200 grain SWC. Intended for 45 ACP, this has no crimp groove. Is this likely to present any problems in a very low end load of 5.5 to 6.0 grains of trail boss?