geegee
Member
I posted this on another forum, but wanted to elicit some other opinions from you folks here as well. Here's my problem:
I bought a used T Series BHP a couple of weeks ago, and returned today from the range after shooting it for the first time. From 15 yards away, I fired 100 rounds of 115 gr. hardball, fifty each of Blazer and Winchester.
Right near round 95 or so, the slide would cycle another round (and cocked the hammer), but when I pulled the trigger, the hammer would drop, but the gun wouldn't fire. I thumbed cocked the remaining shots and was able to fire all of them. It was as though the hammer wasn't being cocked all the way back by the slide. Again, this only happened on the very few last rounds.
Any thoughts on what might be causing this problem?
I bought a used T Series BHP a couple of weeks ago, and returned today from the range after shooting it for the first time. From 15 yards away, I fired 100 rounds of 115 gr. hardball, fifty each of Blazer and Winchester.
Right near round 95 or so, the slide would cycle another round (and cocked the hammer), but when I pulled the trigger, the hammer would drop, but the gun wouldn't fire. I thumbed cocked the remaining shots and was able to fire all of them. It was as though the hammer wasn't being cocked all the way back by the slide. Again, this only happened on the very few last rounds.
Any thoughts on what might be causing this problem?