BigDog1955
Member
- Joined
- Mar 22, 2018
- Messages
- 172
This is a pic of my home made shooting stand, 1 1/2" pvc, 3 - 1' 6" pieces glued together with a 1 1/2" T. then I use 3/4" x1 1/2" x 4 foot wood rails to support the 4' x 4' card board. I use clamps to hold the carboard to the wood some friends use staples. The wood rails slip into the pvc so U can remove to store them, U may have to sand the edges to fit into the pvc, makes for easy removal. I get the card board from electric warehouse because they ship reals of wire on pallets and use the card board as spacers. I staple the targets to the cardboard so they are easy to remove. On the bottom legs of the pvc I drilled 4 holes to accept 10" nails. I drive one into each hole to keep the wind from blowing over the stand. What a hassle when that happens while shooting 300 yards : I also cutoff some location flag wires to 10" and drilled small hole in the top of each rail and stuck the flag wires into the holes so I can see the direction of wind while shooting. Kind of works ok,?? nothing like a ball bearing wind flag, but only a dollar in cost This takes about 5 minutes at the most to assemble and ready to shot. No long rifle ranges here so we have to do it ourselves :bthumb:
a couple of pics:
any questions let me know enjoy
a couple of pics:
any questions let me know enjoy