After much researching I'm still unclear.
Press in the up position. Seat the die, three turns out.
How do you adjust the actual bullet depth?
In theory you insert a loaded round, set the die bullet depth adjustment knob to contact the bullet and then proceed loading your empty cartridges.
Loaded round will not go into the die without undo force. Empty round gets a nasty crimp when inserted with a full press.
Hopefully I do not need to scrap several rounds getting the correct bullet seating depth.
Any advice would be appreciated.
Press in the up position. Seat the die, three turns out.
How do you adjust the actual bullet depth?
In theory you insert a loaded round, set the die bullet depth adjustment knob to contact the bullet and then proceed loading your empty cartridges.
Loaded round will not go into the die without undo force. Empty round gets a nasty crimp when inserted with a full press.
Hopefully I do not need to scrap several rounds getting the correct bullet seating depth.
Any advice would be appreciated.