Just picked up a lee Pro Auto Disk powder measure for my lee 4 hole turret press this last weekend at a gun shop that was closed down on July 1.
Got it home, looked it over...seemed just fine. Then went to mount it on my turret press and found out that it was missing the return spring! So, we're just moving the disk back under the hopper by hand! Obviously, this is a bit of a nuisance.
Does anyone know if I can get a spring locally before I call the folks at Lee and have to wait for it? I don't think my hardware store carries springs, unfortunately....and if they did I wouldn't know exactly what the length of it is.
Also, I can see where this spring would attach to the lever, but where does it attach to the measure? I don't see any rings or anything...am I missing a part there too?
Thanks!
Got it home, looked it over...seemed just fine. Then went to mount it on my turret press and found out that it was missing the return spring! So, we're just moving the disk back under the hopper by hand! Obviously, this is a bit of a nuisance.
Does anyone know if I can get a spring locally before I call the folks at Lee and have to wait for it? I don't think my hardware store carries springs, unfortunately....and if they did I wouldn't know exactly what the length of it is.
Also, I can see where this spring would attach to the lever, but where does it attach to the measure? I don't see any rings or anything...am I missing a part there too?
Thanks!