WhoKnowsWho
Member
I am trying to size my 6.5 Jap Arisaka brass, but the brass doesn't seem to fit the shell holder for use on the press. It fits the shell holder for the trimmer, and for the primer though. And all the measurements of the brass are in spec according to the manual with dimensions.
Lee sent another shell holder when I told them about it, but it is the same... is anyone else using this shell holder? Should I get my dremel and start opening up the shell holder? I could use some help here.
If nothing else, I will e-mail Lee again and see what they say too.
Lee sent another shell holder when I told them about it, but it is the same... is anyone else using this shell holder? Should I get my dremel and start opening up the shell holder? I could use some help here.
If nothing else, I will e-mail Lee again and see what they say too.
